-
Update motor controllers to current firmware
-
We have encountered an error in our library usage and would appreciate some feedback on how to solve it.
we have 16 EtherCAT units (7 drives and 9 I/O modules)
we launch our application in mode …
-
Our motor controllers will control our motors. We need to control our motors to drive our robot.
- [x] Flashing *anything* to our motor controller(s)
Before we can use our motor controllers for anyt…
-
# Todo
- [x] IMU 6050 test with ESP32
- [x] IMU 6050 test with ESP32 publishing to ros2 publisher
- [x] Motor Controller with ros2 subscriber
- [x] Encoder publisher with Int32
- [ ] Encoder publ…
-
Sometimes teams may wish to tune their motor controllers outside of YAGSL. YAGSL currently resets all motor controllers to factory default and applies its own configs to every motor controller. This i…
-
Hello everyone
I'm running into an extremely annoying problem whose cause I can't determine:
inav 7.1.1, speedybee f7v3 in inav 7.1.2
Flight Controller reversed 180°, engine remapping done correctl…
-
@tobyMickelson
Please review Anglerfish to find other settings that are used to properly configure a motor controller. Most of these show up in the Constants class.
You will quickly find that pas…
-
**Describe the bug**
Build error occurs on both Arduino IDE and Platformio
Additionally, it happens with both versions 2.3.3 and 2.3.4.
**Describe the hardware setup**
- Which microcontroller
…
-
We suggest that you configure both Simmagic haptic motor controllers.
The reason is because I want to use it in 4 channels.
It is now available for up to 3 channels. Please allow me to configure 6 c…
-
When connected to a Control+ hub, my large spike prime motor works properly, but when connected to a Boost hub, even manually sliding the power slider does nothing on both c and d ports. I am using th…