-
It's been more than a month since this problem occurred. But I still haven't found a solution, so I'm asking for help here.
I purchased the xy-plotter from the aliexpress site.
When the command is g…
-
The servo `torque_limit` getter and setter are missing a 10 conversion factor:
https://github.com/machinekoder/ar_gripper/blob/59ad095111884504eefb97f22cae3c282b8f8bb1/src/ar_gripper/feetech.py#L70…
-
Hi,
Controlling the stepper motors works fine but Im having troubles controlling the servo, so I decided to measure The PWM on D11 and it is too weak. Peak to peak value is only 0,2 volts and V max is…
-
We used to run a subset of WPT in multiprocess mode in the pre-GitHub CI: https://github.com/nikhilshagri/servo/blob/0750fdc370f766d96933d559e12f3fd566df096d/etc/ci/buildbot_steps.yml#L99 . We should …
-
There are different modes of servo control.
- [ ] #4
- [ ] #5
- [ ] #6
- [ ] #7
-
Create a schematic with the following:
- [x] Servos powered directly from Vbat
- [ ] Logic level converter so PPM signal to control servos from MCU is at 5V
- [ ] MOSFET switch to kill the servos from…
-
This one is very odd.
I'm setting up servos using the P2Servos12 board. I've only created tests within one sequence (a test sequence), so this model is currently not used in my show. However, my s…
-
Once the hardware is in place, we could use the 2019-20 implementation of the thrusters which uses the Adafruit Servo Driver instead of the PWM pins on the Arduinos.
-
Hi all,
My bltouch suddenly stopped working without any wiring or firmware change. No fix is working found all over the internet.
I just measured the voltage when sending m280 P0 S10. And the vol…
-